Metal corner protectors, perforated corner protectors, galvanized steel corner protectors, aluminum corner protectors, 5cm*30m
Still deciding? Take a sample and try it out. >> Get sample
Product Information
Sort: spot goods
Place of Origin: Yiwu City, Zhejiang Province
Brand: highpure
Material: Metal + paper
Packing QTY: 10PCS/CTN
MEAS.: 35cm * 35cm * 35cm
CBM: 0.042875CBM
G.W.: 20.0KGs
Descriptions
Comparison
Product application
Protect the corners from wear and damage, making the 90-degree angles of the concave and convex corners more prominent, the edge lines smoother, fully protect the concave and convex corners, and enhance their strength. It is widely used for the protection of arches, arcs and corners of walls.
Product performance
The metal corner guard tape is made up of two imported high-quality hot-dip galvanized steel strips with a width of 11mm in the center. Through a special process, they are firmly bonded to the paper tape. It not only provides long-term rust prevention but also protects the corner, making it straight and firm.
2. It is suitable for seams at any Angle, especially for preventing cracking at the corners of suspended ceilings and making the corners straight.
3. The width of the metal corner guard tape is 50mm, and each box in the box is 30m long. Compared with traditional corner guard strips, it uses less putty, can be cut to length as needed, has no joints and low loss.
4. Roll-shaped, easy to carry; Easy to cut, reducing waste; Applicable to corners of various shapes; The operation is simple and the construction is convenient.
Product specifications
尺寸：50mm×30m
Colour: White
Packaging: 10 rolls per box
Product base material
The paper tape adheres to galvanized steel or aluminum metal strips
Usage method
1. Measure the length of each side according to the actual situation on site, and cut the metal corner guard tape vertically with scissors to meet the construction length requirements.
2. Apply joint putty on both sides of the corner, fold the metal corner guard band along the center line, and stick the metal steel band surface inside the joint putty (one side of the metal steel band should be stuck inside). Squeeze out the excess putty and use a trowel to smooth the surface clean. When constructing, the metal corner guards at the corners must not overlap; otherwise, it will affect the flatness.
3. After it dries, apply a layer of joint putty on the surface. If necessary, gently sand it with fine sandpaper.
Picture
